Great Plains 40P Assembly Instructions - Manual (Page 3)

1/9/03 118-811M
Great Plains Mfg., Inc.
3 Installation Instructions
Refer to Figure 7
1. Using predrilled holes, remove bolt (1) from
feedercup tray and replace with eye hook (2),
flat washers (3), lock washer (4) and hex nut
(5) supplied in kit. Assemble the eyebolts in
the same manner for all boxes. There are two
eyebolts per feedercup tray, one at each end
of tray. Note: If there are no holes, drill 1/4”
hole (6) on edge of outlets.
Refer to Figure 8
2. Line meter covers with foam seal all the way
around the edges. The two outside meter cov-
ers require an additional 4" strip to be added
to both ends of the cover.
3. Place meter covers over tube outlets not be-
ing used. Place Seedtube corks in tubes at
each end of the box. See page 6 for place-
ment. Make sure there is a good seal to rear
box panel.
Refer to Figure 9
4. Use tarp strap to hold meter covers in place
by fastening one end to the eye hook pulling it
over the meter cover and hooking it to the box
divider
Assembly Instructions for 118-826A Baffle Package
Figure 7
Feedercup Tray
Figure 8
Foam Seal
Figure 9
Eye Hook to Box Divider
19252
19251
19254
19253