Great Plains TC5319 (S/N A1420X+) Parts Manual - Manual (Page 73)

Revision Comments Part Description Part No. Ref.
Image No. dwg43169
SHANK SUB WELDMENT 569-304H 1.
SHANK SUB-WELDMENT 569-007H 2.
HHCS 3/4-10X2 1/2 GR5 802-212C 3.
WASHER LOCK SPRING 3/4 PLT 804-023C 4.
NUT HEX 3/4-10 PLT 803-027C 5.
POLYGON SLEEVE BEARING 817-974C 6.
SHANK SUB WELDMENT 569-303H 7.
HHCS 1-8X6 1/4 GR8 SPTHD 569-151D 8.
NUT HEX TOP LOCK 1-8 PLT 803-168C 9.
BUSHING 569-089D 10.
SHANK SPRING BOLT WELDMENT 569-193H 11.
HHCS 3/4-10X4 1/2 GR5 802-192C 12.
SPRING COMP 3.625OD .6875W 16L 807-287C 13.
WASHER FLAT 1 USS PLT 804-028C 14.
NUT HEX JAM 1-8 PLT 803-030C 15.
SHANK ASSY MED 569-305V 16.
SHANK CHISEL 1 1/4X2X25 1/2 820-368C 17.
HHCS 5/8-11X4 1/2 GR5 802-100C 18.
WASHER LOCK SPRING 5/8 PLT 804-022C 19.
NUT HEX 5/8-11 PLT 803-021C 20.
HHCS 1/2-13X3 GR5 802-039C 21.
WASHER LOCK SPRING 1/2 PLT 804-015C 22.
NUT HEX 1/2-13 PLT 803-020C 23.
shown CHISEL POINT 5/8X2X15 820-032C 24.
TWISTED SHOVEL 1/2X3X23 RH 820-336C 24.
TWISTED SHOVEL 1/2X3X23 LH 820-337C 24.
TWISTED SHOVEL 1/2X4X26 RH 820-332C 24.
TWISTED SHOVEL 1/2X4X26 LH 820-333C 24.
CHISEL POINT WINGED 5/8X2X15 569-162H 25.
PLOW 1/2-13X2 1/2 GR5 802-590C 26.
WASHER FLAT 1/2 USS PLT 804-017C 27.
NUT HEX TOP LOCK 1/2-13PLT 803-342C 28.
07/14/14 - 73 - 566-224P
Table of Contents Part Number Index
Section 6: Shanks
Chisel Shank Assembly (569-195S S/N A1667X+)
(Applies to TC5109, TC5111, TC5113, TC5115, TC5313, TC5315, TC5317, TC5319, TC5321, TC5323 only)