Great Plains 116-283A Installation Instructions - Manual (Page 8)

8 Great Plains Manufacturing, Inc. Front Page Part Lists LOUP 2/3 CHANNEL SHAFT MONITOR
116-284M Front Page Part Lists 2013-08-27
Install Two Channel Harnesses
Review the “General Harness Guidelines” on page 7.
Refer to Figure 10
41. Select one new:
318917 HARNESS 2 SHAFT MONITOR LOUP
Dress the harness across the drill, making sure that
the leads labelled LEFT and RIGHT are routed to
their respective seed boxes.
42. Select one new:
833-596C SHAFT MONITOR EXT. 25’4P WP
Note: On a two-point drill, this extension cable may not
be needed. If so, continue at step 44.
43. Dress the extension cable along the tongue, or
through any accessory hitch. Make sure that the
connector that mates with the 2-way harness
is
toward the rear.
Verify that the forward end of the extension cable
reaches the hitch.
44. Route the 2-way leads through available holes and
near attachment points for cable ties.
45. Connect each 2-way lead to its respective shaft
sensor lead .
46. Connect the extension cable to the 2-way
harness .
47. Select all of new (not shown):
800-052C HOSE CLIP 5/8 I.D.
48. These clips are used to secure the sensor leads to
the flange that joins each seed box to its tray.
Allocate them for equal clip spacing on each box.
Refer to Figure 10
49. At each desired support point, remove the existing:
802-196C HFSS 1/4-20X5/8 GR5
803-088C NUT HEX LOCK 1/4-20 FLG
Save the nut .
50. Select all of new:
802-257C HFSS 1/4-20X3/4 GR5
Insert the sensor lead in the clip . Secure the clip
to the flange with the new screw , and the saved
nut .
51. Select all of new (not shown):
800-112C CABLE TIE .19X7.25 1.75D 50LB
52. Starting at the inner-most clips , secure each
cable along its route, leaving a little slack (more at
pivots).
Continue at “Install Monitor Console” on page 10.
Figure 10
Two Channel Harness
34215
25
LEFT RIGHT
4-pin
weatherpak
3-pin
weatherpak
21
24 24
4-pin
weatherpak
25
21
21
21
24
21
26
14
Figure 11
Tray-to-Box Screws
34219
52
53
52
53
53
17
14
17
53
15
14