Great Plains 1205NT Predelivery Manual User Manual
Page 15
3/24/06
150-131Q
13
Setup
Hitching to Tractor
Refer to Figure 7.
1.
Figure 7
Hitching to Tractor
13944
Back tractor to drill. Using the screw jack, ad-
just drill tongue to get drawbar under upper
hitch plate (1).
2.
Align rear hole in upper hitch plate with large
hole in drawbar. Place lower hitch plate (4)
under drawbar and attach to upper hitch plate
with two 5/8 x 4 inch bolts (5), flat washers (6)
and nylock nuts (7).
3.
Bolt top upper hitch plate through hole in
drawbar to lower hitch plate with 1 x 5 1/2 inch
bolt (8), USS flat washer (3) and nylock nut
(2).
4.
Securely attach safety chain to drill hitch with
a 3/4 x 2 1/4 inch bolt (10), safety washer (11),
lock washer (12) and nut (13). Then attach to
tractor drawbar.
5.
Store jack on top of tongue as shown in
Figure 8
Jack in Storage Position
13940