Small seeds row shut-off – Great Plains 3P806NT Material Rate User Manual
Page 28
26
3P806NT
Great Plains Manufacturing, Inc.
151-143B
2011-10-21
When drilling, check seeding rate by noting acres drilled,
amount of seed added to drill and seed level in drill box.
If you are seeding more or less than desired, adjust rate
slightly to compensate for field conditions.
Small Seeds Row Shut-Off
If alternate row spacing is required for small seeds,
optional plugs are available to block flow inside the seed
box tray.
1.
Clean-out seed. The seed box must be empty prior
to inserting plugs. See “Small Seeds Box
Clean-Out” in Operator manual.
2.
Before installing plugs, inspect the seed boxes for
existing factory-installed plugs. These are blocking
extra unused seed ports. You may want to identify
these plugs with an indelible marker.
3.
Insert one plug at each row to shut off. Verify the
seed hose path before inserting the plug, as some
hoses do not make a strictly vertical drop to their row
units.
4.
Review seed rate settings prior to planting. Perform
calibration calculations with the actual active row
count.
When removing plugs to restore rows to operation, be
sure to not disturb a factory-installed plug.
Figure 13
Small Seeds Tube Plug
27407