Great Plains DICKEY-john AI-120 - Manual (Page 15)

Important: Accuracy of Swath Command is dependent upon accurate measurements
between the GPS receiver and where seed is placed in the ground. Failure to enter
exact measurements will impact the system’s performance to shut row sections off at
the proper location within the field. Refer to AI-120 & IntelliAg manual that these
measurements are entered correctly before making any further adjustments.
Timing
Timing is an adjustment to gap or overlap of product application when entering a
headland and using section control. Two timing options to turn sections on and off are
required.
•
ON TIME- On Time establishes when actual product application starts after
the sections are switched on.
•
OFF TIME- Off Time establishes when actual product application stops after
the sections are switched off. Off time cannot exceed the On time setting.
• **Note: This is a SPEED based timing, meaning that you must maintain the SAME
speed when entering and leaving your headlands.
Dialing in Swath Command Sec. 9
Setting Timing
- 1. Select the wrench button
- 2. Select Implement
- 3. Select Section Control
- 4. Select Timing
2
3
4
From this screen you may dial in your Swath
Command by touching one of these 2 options.
When done setting timing then
return to the home screen by
touching this button.
2012-12 15 401-909M