Hyd. drive - changing populations, Sec. 4 – Great Plains DICKEY-john AI-120 User Manual
Page 6
Hyd. Drive - Changing Populations
Select the Summary Button
This will take you to the
summary page. From there
touch the yellow box as shown
here.
**Note: This is assuming that the system is unlocked. See the unlock section on how to unlock the
system.
This is the Summary Page
Sec. 4
Next make sure that Channel 1
is a black box , as shown here,
by touching it.
This will bring you to the area you can
change your Populations. NOTICE: Enter
the amount in THOUSAND SEEDS per
acre. Example: If you wish to plant 34,000
seeds per acre then you would enter 34.0
This is your target rate, the
amount you wish to seed or your
population.
Next you would make sure your
MAX Rate is set (maximum rate you wish
to plant).
Then you would make sure your
MIN Rate is set (minimum rate you wish
to plant).
** Preset Method is disabled in this example.
NOTE: Once you have entered your changes
by touching the highlighted area to be changed
you MUST touch the
to
accept.
Enter the percentage you wish to
increase or decrease your population on
the go.
2012-12
6
401-909M