Yamaha LS9 - Manual (Page 216)

216
Setting the network address
LS9-16/32 Owner’s Manual
Here’s how to set the network address that will be required when you use the LS9’s NETWORK
connector to connect it to a Windows computer.
1
In the DISPLAY ACCESS section, press the
[SETUP] key repeatedly to access the MISC
SETUP screen.
1 NETWORK field
This shows the values of network-related parameters.
B NETWORK SET button
This accesses the NETWORK popup window, where
you can make network-related settings.
C MAC ADDRESS field
This is the MAC (Machine Access Control) address
specified for identifying a host within a network. This
field is only for display, and cannot be edited.
2
Move the cursor to the NETWORK SET but-
ton in the NETWORK field, and press the
[ENTER] key to access the NETWORK
popup window.
1 IP ADDRESS field
This is a number (IP address) assigned to identify each
device on the Internet or within an LAN (Local Area
Network).
B GATEWAY ADDRESS field
This specifies the number (gateway address) that iden-
tifies a device (gateway) that allows data of differing
media or protocol to be exchanged within a network to
allow communication.
C SUBNET MASK field
This defines the number of bits (of the IP address used
within the network) that will be used as the network
address that distinguishes the network.
D LINK MODE field
Select either 100BASE-TX (transmission speed: max-
imum 100 Mbps) or 10BASE-T (transmission speed:
max 10 Mbps) as the specification used for communi-
cation via the NETWORK connector.
3
Move the cursor to the LINK MODE field,
and use the dial or the [DEC]/[INC] keys to
select a communication protocol for the
NETWORK connector as appropriate for the
network to which the LS9 is connected.
4
Move the cursor to each remaining field in
the screen, and use the dial or the [DEC]/
[INC] keys to specify each address.
If you are connecting the LS9 to your computer in a
one-to-one connection, we recommend that you make
the following initial settings.
● IP address
192.168.0.128 or similar (it must not conflict with the
IP address of any other device on the network)
● Gateway address
192.168.0.1 or similar (it must not conflict with the IP
address of any other device on the network)
● Subnet mask
255.255.255.0 or similar
Setting the network address
• The network address can be changed only by users who have administrative privileges.
• For details on network settings, refer to the LS9 Editor installation guide which can be downloaded from the following Yamaha website.
http://www.yamahaproaudio.com/
NOTE
1
LS9-32
2
3
1 3
2 4
• Be aware that if the specification does not match, communi-
cation will not occur correctly.
NOTE