Yamaha LS9 User Manual
Page 98
98
Changing the output patching
LS9-16/32 Owner’s Manual
F
Delay time setting knob
This knob sets the delay time of the output port. Move
the cursor to this knob and use the dial or the [DEC]/
[INC] keys to adjust the setting. The delay time value
is shown below the knob, using the units selected in
the DELAY SCALE field (
3
).
G
DELAY button
Switches the delay on/off for the output port.
H
ø
(phase) button
Switches the phase of the signal assigned to the output
port between normal phase (black) and reverse phase
(orange).
I
ATT knob
Adjusts the amount of attenuation/boost for the signal
assigned to the output port. To change the setting,
move the cursor to this knob in the screen, and use the
dial or the [DEC]/[INC] keys. You can adjust the value
in 1.0 dB steps in a range of -96 – +24 dB. The current
value is shown immediately below the knob.
J
Level meter
This meter shows the signal level of the channel
assigned to the output port.
3
To assign a channel to an output port, move
the cursor to the channel number field of
that port, and press the [ENTER] key.
The OUTPUT CH SELECT popup window will
appear. This popup window contains the following
items.
1
Category tab
This selects the type of channel that will be shown in
the lower part of the window. Each tab corresponds to
the following channels.
●
OUT CH
Output channels (MIX channels 1–16, MATRIX
channels 1–8, STEREO L/R channel, and MONO
(C) channel) will be shown.
●
MONITOR OUT
The MONITOR OUT L/R/C channels will be
shown.
●
CH 1-32 {1-32/33-64}
INPUT channels 1–32 {1–64} will be shown.
B
Channel select button
This selects the channel that is assigned to the output
port.
4
Use the category tabs and the channel
select buttons to select the send-source
channel.
5
Move the cursor to the CLOSE button and
press the [ENTER] key to return to the pre-
vious screen.
If PATCH is turned on in the CONFIRMATION field
of the PREFERENCE popup window, a confirmation
dialog box will appear when you attempt to modify the
patching.
If STEAL PATCH is turned on, a confirmation dialog
box will appear if you attempt to change a location
that is already patched to another location. (For
details, refer to
6
Make settings for delay, phase, and
attenuator as necessary.
7
Repeat steps 3–6 to assign channels to
other output ports.
8
When you’ve finished making settings,
move the cursor to the CLOSE button (or to
the
× symbol in the upper right of the win-
dow), and press the [ENTER] key to return
to the previous screen.
1
2
LS9-32
• If you assign CH 1-32 {1-32/33-64} to an output port, the
selected INPUT channel will be output directly from the corre-
sponding output port. In this case, the channel select button
in the OUTPUT PORT popup window will indicate “DIR CH
xx” (xx = channel number). (For details on direct output
HINT