Yamaha LS9 - Manual (Page 68)

68
Signal flow for output channels
LS9-16/32 Owner’s Manual
■ STEREO channel / MONO (C) channel
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Each of these channels process the signal sent from the input channels to the STEREO bus or MONO (C) bus, and
send it to an output port or MATRIX bus. If input channels are set to LCR mode, the STEREO (L/R) channels and
the MONO (C) channel can be used together as a set of three output channels.
When the LS9 is in the initial state, the STEREO channel is assigned to the 2TR OUT DIGITAL jack.
■ MATRIX channels 1–8
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
These channels process the signals sent from MIX channels and STEREO/MONO channels to MATRIX buses,
and send them to the corresponding output ports.
● ATT (attenuator)
Attenuates/boosts the level of the signal.
● 4 BAND EQ (4 band equalizer)
This is a parametric EQ with four bands; HIGH, HIGH
MID, LOW MID, and LOW.
● COMP/COMPANDER/EXPAND (compressor/com-
pander/expander)
This is a dynamics processor that can be used as a com-
pressor, compander, or expander.
● LEVEL
This adjusts the output level of the channel.
● BALANCE (STEREO channel only)
Adjusts the left/right volume balance of the STEREO (L/
R) channel.
● ON (on/off)
Turns the output channel on/off. If this is off, the corre-
sponding channel is muted.
● TO MATRIX ON/OFF (MATRIX send on/off)
This is an on/off switch for the signal sent from the MIX
channels, STEREO (L/R) channel, or MONO (C) channel
to each MATRIX bus 1–8.
● TO MATRIX LEVEL 1-8 (MATRIX send levels 1–8)
This adjusts the send level of the signal sent from the MIX
channels, STEREO (L/R) channel, or MONO (C) channel
to each MATRIX bus 1–8. As the position from which the
signal is sent to the MATRIX bus, you can choose either
pre-fader or after the [ON] key.
1 2 ... ... 15 16
ST
L R
MATRIX CUE
ON
ON
ON
To OUTPUT PATCH
To MONITOR SELECT
To RECORDER IN PATCH
ON
To OUTPUT PATCH
To RECORDER IN PATCH
MIX
M
O
N
O
(C) 1 2 7 8 L R
STEREO L,R,MONO(C)
To RACKIN PATCH
To OUTPUT PATCH
STEREO
INSERT OUT L,R,MONO(C)
STEREO
INSERT IN L,R,MONO(C)
INSERT POINT
PRE FADER
PRE EQ
INSERT OUT
INSERT OUT
PRE EQ
METER
INSERT
PRE EQ
ATT
POST EQ
4BAND
EQ
EQ OUT
METER
DYNA OUT
METER
GR METER
Keyin
Self PRE EQ/Self POST EQ/MIX13-16 OUT/
ST(L,R,MONO(C)) POST EQ
PRE EQ
INSERT OUT
PRE FADER
METER
INSERT
PRE FADER
INSERT OUT PRE FADER
LEVEL BAL
(PRE FADER)PFL / (POST ON)AFL
MATRIX1,3...7
MATRIX2,4...8
CUE ON
PAN
LEVEL
LEVEL
LEVEL
PRE FADER / POST ON
To MATRIX
VARI
PRE FADER / POST ON
To MATRIX
VARI
STEREO
POST ON
METER
To STEREO OUT L+C,R+C
POST ON
STEREO OUT
L,R,MONO(C)
STEREO OUT L
STEREO OUT MONO(C)
STEREO OUT R
STEREO OUT L+C
STEREO OUT R+C
To OUTPUT PATCH
To RECORDER IN PATCH
COMP
COMPAND
EXPAND
ON
1 2 ... ... 15 16
ST
L R
MATRIX CUE MIX
M
O
N
O
(C) 1 2 7 8 L R
MATRIX1-8
To RACKIN PATCH
To OUTPUT PATCH
MATRIX
INSERT OUT 1-8
MATRIX
INSERTIN1-8
CUE ON
INSERT POINT
PRE FADER
PRE EQ
INSERT OUT
INSERT OUT
PRE EQ
METER
EQ OUT
METER
INSERT
PRE EQ
ATT
POST EQ
4BAND
EQ
DYNA OUT
METER
COMP
COMPAND
EXPAND
PRE FADER
METER
INSERT
LEVEL
PRE FADER
INSERT OUT
PRE FADER
PRE EQ
INSERT OUT
Keyin
Self PRE EQ/Self POST EQ/MIX13-16 OUT/
MATRIX1-8 POST EQ
(PRE FADER)PFL / (POST ON)AFL
POST ON
METER
POST ON
MATRIX OUT 1-8
To OUTPUT PATCH
To MONITOR SELECT
To RECORDER IN PATCH
GR METER