Yamaha LS9 - Manual (Page 97)

97
9
Input/output patching
Changing the output patching
LS9-16/32 Owner’s Manual
● Selecting the output channel for each
output port
Here’s how to select the output channel that will be the
output source for each output port.
1
In the DISPLAY ACCESS section, press the
[SETUP] key repeatedly to access the SYS-
TEM SETUP screen.
In the OUTPUT PORT SETUP field in the center of
the screen, you can select the output port assigned to
the output channel from the following choices.
● OMNI 1-8 {1-8/9-16}
Select the output channels assigned to OMNI OUT
jacks 1–8 {1–16}.
● SLOT {1/2} 1-8/9-16
Select the output channels assigned to output chan-
nels 1–16 of the slot(s) {1/2}.
● 2TR OUT
Select the output channel assigned to the 2TR
OUT DIGITAL jack.
2
In the OUTPUT PORT SETUP field, move
the cursor to the button for the output ports
that you want to set, and press the [ENTER]
key.
The OUTPUT PORT popup window will appear,
allowing you to make output port settings.
1 INITIALIZE button
This initializes the settings for the displayed output
ports. When you move the cursor to this button and
press the [ENTER] key, a dialog box will ask you to
confirm the Initialize operation.
B I/O card type
If the output channel of a slot is selected for opera-
tions, this area indicates the type of I/O card installed
in that slot.
C DELAY SCALE field
Use the following buttons to select the units for the
delay time displayed below the delay time setting
knob (
6 ).
● METER
The delay time is displayed as a distance in meters,
calculated as the speed of sound at an air tempera-
ture of 20°C (68°F) (343.59 m/s)
× delay time
(seconds).
● FEET
The delay time is displayed as a distance in feet,
calculated as the speed of sound at an air tempera-
ture of 20°C (68°F) (1127.26 feet/s)
× delay time
(seconds).
● SAMPLE
The delay time is displayed in units of samples. If
you change the sampling frequency on which the
LS9 operates, the number of samples will change
accordingly.
● msec
The delay time is displayed in units of millisec-
onds.
D Output port
This is the type and number of the output port to
which the channel is assigned.
E Channel select button
This button selects the channel assigned to the output
port. The number of the currently selected channel is
shown.
LS9-16
LS9-32
3 2 1
5
6
7
9
J
4
8