Humboldt H-3185B CONTROLLER - Manual (Page 15)

- 15 -
© 2008 Humboldt Manufacturing
temperature changes as well as the overall cycling time. It is not recommended
that this setting be changed.
5.3 Setting Termination State
1. Continuing from section 5.2, while the green display is alternating between
“HLd.b” and “2.0” as in the previous section, push the Mode button
again until the green display reads “tEr.S” (Figure 12). This is the
Termination State function. The green display will alternate between “tEr.S”
and “Stby”. Options for this function are Last Set point “LASt”, Default Set
point “dEFt”, and Standby “Stby”.
Figure 12
2. To change this setting, press the up or down arrow button until
the green display shows the desired setting.