Humboldt H-3185B CONTROLLER - Manual (Page 9)

- 9 -
© 2008 Humboldt Manufacturing
Figure 5
3. Follow step 3 in section 4.1 to return to the temperature readings and begin the
operation.
Note: When in Normal mode operation, the controller will try to maintain the
temperature of the set value (green display). If it is desired to maintain the test
samples at a certain temperature, Normal mode should be used. If the controller
was on standby when power to the controller was disconnected and later
reconnected, the controller will automatically go into normal mode when it
receives power.
4.1.2 Standby Mode
1. To change to Standby mode, follow the step 1 in section 4.1 for changing the
operational mode.