Humboldt H-3185B CONTROLLER - Manual (Page 17)

- 17 -
© 2008 Humboldt Manufacturing
5.5 Setting Power Fail-Resume Options
1. Continuing from section 5.4, while the green display is alternating between
rcY.n” and the set number of cycles as in the previous section, continue pressing
the Mode button until the green display reads “PFrE” (Figure 14). The
display will alternate between “PFrE” and “on”.
Figure 14
2. To change the option, press the up or down arrow button until the
option is displayed.
Note: This setting controls what happens when the power fails during a
cycling operation. The controller is preset to resume the cycling when power
returns. The options are “on” and “OFF”.