Humboldt H-3185B CONTROLLER - Manual (Page 16)

- 16 -
© 2008 Humboldt Manufacturing
Note: The Termination State tells the controller what to do at the end of the test. The
controller is preset to go to standby when the testing is complete.
1.
5.4 Setting Number of Cycles
1. Continuing from section 5.3, while the green display is alternating between
“tEr.S” and “Stby” as in the previous section, push the Mode button
again
repeatedly until the green display reads “”rcY.n” (Figure 13). The green display
will alternate between “rcY.n” and the number of cycles desired minus one (i.e
for 36 total cycles, it should display 35).
Figure 13
2. To change the number of cycles, press the up or down arrow button
until the desired number minus one is displayed.