Dustless DustDroid 600 - Manual (Page 4)

dustlesstools.com 800.568.3949
4
DustDroid™ 600 & DustPro™ 600 HEPA Industrial Vacuums
Explanation of Warnings and Symbols __________________________________________________
The following symbols are used in the operating instructions to highlight areas of particular importance:
Operational Safety – This symbol will be shown in these Operating Instructions next to all safety precautions that
are to be taken in order to ensure prevention of injury. Follow these instructions and take special care in these circum-
stances. In addition to these instructions, the general safety precautions and the local accident prevention guidelines
are also to be followed. Please check, whether there are special regulations for the particular job site.
Safety Goggles/ Ear Protection – Information, instructions, and restrictions with regards to possible risks to per-
sons or extensive material damages.
Electrical Warning – Warning against dangerous voltages.
Organizational Measures ____________________________________________________________
The Operating Instructions are to be kept near the location where the machine is located and must be reachable all the time!
In addition to the Operating Instructions general and legal regulations regarding accident prevention and environmental protection
must be with and indicated every time! Such duties may for example relate to the handling of hazardous substances or to the provi-
sion and wearing of personal protection equipment as well as compliance with local traffic regulations.
The Operating Instructions must be supplemented by instructions including the duty to supervise and report relating to particular local
working practices, for example work organization, work procedures, and personnel allocation. Personnel entrusted with working with
the machine must have read the Operating Instructions before starting the work; in particular the chapter about Safety Instructions.
These have to be read before starting any work with the machine. This particularly applies to incidental activities such as setting up
the machine, carrying out maintenance work, or training staff to work with the machine.
From time to time the working practices of the staff are to be checked regarding awareness of safety and hazards.
Personnel must tie back long hair and not wear loose clothing or jewelry and rings. There is a risk of injury through getting stuck or
being drawn into moving machinery.
Take notice of all safety and hazard notices on the machine.
All safety and hazard notices on the machine must be kept complete and legible. If safety-critical changes occur to the machine or its
performance, the machine must be shut down immediately! The cause of the fault has to be established immediately and has to be
repaired before starting the work again.
Changes, add-ons, or conversions of the machine which might have an influence to the safety of the machine must not be undertaken
without the permission of the manufacturer. This applies in particular to the fitting and adjustment of safety devices and to welding
on major and load bearing parts.
Spare parts must always comply with the technical requirements and the specifications of the manufacturer. This is always guaran-
teed with original spare parts of the manufacturer.
Safety Instructions The following safety
instructions must be followed as shown here. Failure to
do so may result in hazard to health or possible death.
Use personal protection equipment if necessary or required by regulations!