Dustless HEPA Kit 16006 - Manual (Page 4)

4
Leg Assembly
Turn tank upside down. Front legs are on either side of the drain port opening. These front legs do not have the small hooks
on either side. The back legs do have the hooks. These hooks are for the hose to rest on when in storage.
Align legs with openings provided on bottom of the canister and slide into place. The holes will only alig in proper position
for front and back legs. Insert black support screw into hole and tighten screw with a Phillips screwdriver. Repeat with
remaining legs.
Turn cleaner tank right side up.
Place intermediate cover right side up and set on top of the tank.
HEPA Filter Assembly
Your HEPA Filter is preassembled, to your vacuum, at the factory, so the following are the
directions for reinstallation:
To install the HEPA filter properly, place the lid upside down. Install the HEPA filter with the rubber
gasket down so the rubber gasket rests on a rib of the lid. The HEPA filter is held in place with a rubber
sealed washer and wing nut that are tightened down. The washer is installed with the rubber side
down. Make sure the HEPA filter cover support part number 13205 is in place before the HEPA filter
cover part number 13301 is installed. Micro-Prefilters are installed correctly when the cardboard collar
with the rubber gasket is fitted over the intake port on the inside of the barrel. Please refer to the
installation instructions on the Micro-Prefilter packaging for proper installation.
Turn right side up.
Screw the Brass Plug into the top of the lid - only finger tight!! Do not over tighten. This part must be
in place to maintain suction.
The on/off switch is located on the side of the motor cover.
Attach Tool Tray (see picture)
Align the three slots on the edge of the tool tray with the three guides on the
rear side of the tank and press the tool tray toward the tank as you push the
tray down. The two locking tabs will slide under the rim of the tank and
catch. By pushing the tray down and toward the tank it will lock into place.
Attach hose, wands and
cleaning tools
Hose and tools are stored on the unit. The
hose will loop around motor and through the
two outside holes of the tool tray.
For convenience, additional tools can be stored on tool tray when not in use.
To Use Accessories
Push hose into tank port; twist hose to tighten or loosen connection.
The wands and tools attach to hose in the same manner.
ASSEMBLY