Cardinal Industries 225 WEIGHT INDICATOR - Manual (Page 45)

CALIBRATION AND SETUP, CONT.
1. BAUD=X XXXXXX (PRINTER PORT BAUD RATE)
displayed the current setting for the BAUD=
Otherwise, press the 1 key, the eric keys, enter the
value for the printer port baud rate and then press the ENTER key to save the new
setting and return to the PRINTER SETUP MENU. Allowable values are 0 through 13.
0 = 3 8 = 28800 12 = 115200
1 = 6 9 = 38400 13 = 230400
2 = 1
3 = 2400 7 = 19200 11 = 76000
RITY RATE)
l be shown. Note that X is the current value and XXXX is the description.
If the setting displayed is acceptable, proceed to the next setup parameter.
Otherw
ey, the ENTER key and then using the numeric keys, enter the
value for the printer parity rate and then press the ENTER key to save the new setting
and return to the PRINTER SETUP MENU. Allowable values are 0, 1 or 2.
0 = NONE (No Parity) 1 = Odd Parity 2 = Even Parity
3. BITS=X (PRINTER DATA BITS)
With the PRINTER SETUP MENU displayed the current setting for the BITS=
n. Note that X is the current value. If the setting displayed is
key, the ENTER key and then using the numeric keys, enter the
value for the printer data b key to save the new setting
and return to the PRINTER SET
4. STOP
With the PRINTER SETUP MENU displa STOPS=
parameter will be shown. Note that X is the current value. If the setting displayed is
accep
Otherwise, press the 4 key, the ENTER key and then using the numeric keys, enter the
value for the printer stop bits and then press the ENTER key to save the new setting
and return to the PRINTER SETUP MENU. Allowable values are 1 or 2.
With the PRINTER SETUP MENU
parameter will be shown. Note that X is the current value and XXXXXX is the actual
baud rate. If the setting displayed is acceptable, proceed to the next setup parameter.
ENTER key and then using the num
00 0 4 = 480
00 5 = 9600
200 6 = 14400 10 = 57600
2. PARITY=X XXXX (PRINTER PA
With the PRINTER SETUP MENU displayed the current setting for the PARITY=
parameter wil
ise, press the 2 k
parameter will be show
acceptable, proceed to the next setup parameter.
Otherwise, press the 3
its and then press the ENTER
UP MENU. Allowable values are 7 or 8.
S=X (PRINTER STOP BITS)
yed the current setting for the
table, proceed to the next setup parameter.
8200-M538-O1
y 225 Installation
Page 41