Freedom Designs Freedom CGX - Manual (Page 30)

FREEDOM DESIGNS, INC. 2241 Madera Rd. Simi Valley, CA. 93065 800-331-8551 Fax 888-582-1509
www.freedomdesigns.com
28
Adjustments
Tilting the Freedom CGX™
With the chair on a level surface:
1. Set the wheel locks.
2. Hold the handgrips with both hands.
3. Press down and hold the foot tilt lever with
your right foot.
4. Push the back handles forward for less tilt or
pull rearward for greater posterior tilt.
5. When the desired tilt is achieved, lift up on
your foot to engage the tilt lock mechanism.
6. Set the lockout for the foot tilt lever after the
desired tilt angle has been achieved.
Locking the Tilt Foot Lever.
A tilt lever locking pin is located on the frame (see
picture at right). Remove this pin before adjusting
seat tilt angle. When the desired seat angle is
achieved, re-install the locking pin.
The locking pin must be installed whenever
the chair is in motion.
Changing Frame and Seat Width
The seat and frame can be widened in 1”
increments. The frame can be widened independ-
ently to allow for additional lateral stability.