Freedom Designs Freedom CGX - Manual (Page 31)

29
05/15/08
Cleaning
It is important for optimum performance to clean and maintain your Freedom CGX™ .
We recommend that the frame finish be cleaned with mild soap and water.
Maintenance
1. In order to operate the Freedom CGX™ properly and safely, routine maintenance will extend
the life and efficiency of your wheelchair.
Safety Inspection Checklist
Follow these maintenance procedures for optimum performance of your Freedom CGX™
wheelchair:
1. Check to see that the wheelchair rolls straight.
2. Tires: Check for flat spots, wear and proper inflation.
3. Wheel lock:
a. Check to see that the locks engage easily.
b. Check that the locks are free of wear
c. Check to see that the locks do not interfere with the tires when rolling.
4. Ensure that all fasteners are secure.
5. Casters: Inspect axle for proper tension. Spin the caster. The caster should spin freely and
come to a gradual stop.
Storage
The Freedom CGX™ folds down to a small unit and the rear wheels may be removed. We
suggest when storing the wheelchair, that it be stored in an indoor, cool and dry area.
To widen the frame:
Remove the screws (6) located at the lower
arrows (shown at right) under the frame cross
members on each side. Slide the frame out to
desired width. Align holes in cross members with
holes in telescoping frame tubes. Re-install the
screws and tighten securely.
To widen the seat and back:
Remove the (4) screws at the 2 center arrows on
underside of each side of the seat and the (1)
screw on the back spreader bar at the top arrow
(shown at right). Slide the frames out to desired
width, align holes and re-install screws. Tighten
securely.