NISSAN 2011 Altima Hybrid - Owner's Manual - Manual (Page 328)

1. Locate the fusible link box behind the engine
air cleaner.
2. Push the tab in and lift up
᭺
A to remove the
lid and expose the remote positive battery
terminal
᭺
B .
3. If the booster battery is in another vehicle
᭺
F , position the two vehicles,
᭺
E and
᭺
F , to
bring their batteries near each other.
Do not allow the two vehicles to touch.
4. Apply the parking brake. Move the shift se-
lector to P (Park). Switch off all unnecessary
electrical systems (lights, heater, air condi-
tioner, etc.).
5. Remove vent caps on the battery (if so
equipped) of the vehicle with battery for
booster
᭺
F . Cover the battery with an old
cloth
᭺
G to reduce explosion hazard.
6. Connect jumper cables in the sequence il-
lustrated (
᭺
A ,
᭺
B ,
᭺
C ,
᭺
D ).
CAUTION
● Always connect positive (ϩ) to positive
( ϩ) and negative (Ϫ) to body ground (for
example, strut mounting bolt, engine
lift bracket, etc.) — not to the battery.
● Make sure the jumper cables do not
touch moving parts in the engine com-
partment and that the cable clamps do
not contact any other metal.
7. Start the engine of the booster vehicle and
let it run for a few minutes.
LCE0144
In case of emergency 6-9