NISSAN 2014 JUKE - Owner's Manual - Manual (Page 104)

SIC3664
The windshield wiper and washer operates
when the ignition switch is in the ON position.
Push the lever down to operate the wiper at the
following speed:
*
1 Intermittent — intermittent operation can be
adjusted by turning the knob toward
*
A
(Slower) or
*
B (Faster).
*
2 Low — continuous low speed operation
*
3 High — continuous high speed operation
Push the lever up
*
4 to have one sweep
operation of the wiper.
Pull the lever toward you
*
5 to operate the
washer. Then the wiper will also operate several
times.
Pulling up the wiper arm:
The wiper arm should be in the up position when
replacing the wiper.
To pull up the wiper arm, push the lever
*
4 up
twice when the ignition switch is in the “OFF”
position within 1 minute. The wiper operation
stops in mid-operation.
To replace the wiper arm, place the wiper arm in
the down position and then push the lever
*
4
up once.
CAUTION
. This function can be operated even
if the ignition switch is in the “ON”
position. However, to prevent an
accident or damage when pulling
up the wiper arm, be sure to observe
the following precautions.
— Make sure the shift lever is in
the P (Park) position (Continu-
ously Variable Transmission
models).
— Make sure the shift lever is in
the N (Neutral) position, with the
parking brake fully applied
(Manual Transmission models).
— Never allow the passengers to
operate the windshield wiper
switch inadvertently.
. Do not operate the windshield wiper
while the wiper arm is pulled up. The
wiper arm may be damaged.
Instruments and controls 2-33