Keyfob -23 – NISSAN 2014 JUKE - Owner's Manual User Manual

Page 304

Advertising
background image

SDI2134

KEYFOB

Replace the battery in the keyfob as follows:

1. Remove the screw.

2. Insert a small screwdriver into the slit of the

corner and twist it to separate the upper part
from the lower part. Use a cloth to protect

the casing.

3. Replace the battery with a new one.

Recommended battery:

CR1620 or equivalent

.

Do not touch the internal circuit and

electric terminals as doing so could
cause a malfunction.

.

Hold the battery by the edges. Holding

the battery across the contact points will
seriously deplete the storage capacity.

.

Make sure that the

+ side faces the

bottom of the case.

4. Close the lid securely and install the screw.

5. Operate the buttons to check its operation.

See a NISSAN dealer if you need any assistance
for replacement.

FCC Notice:

For USA:

This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received, including interference that
may cause undesired operation.

Note: Changes or modifications not ex-
pressly approved by the party responsible

for compliance could void the user’s
authority to operate the equipment.

For Canada:

This device complies with RSS-210 of
Industry Canada. Operation is subject to
the following two conditions: (1) this
device may not cause interference, and
(2) this device must accept any interfer-
ence, including interference that may
cause undesired operation of the device.

Maintenance and do-it-yourself

8-23

Advertising