NISSAN 2014 JUKE - Owner's Manual - Manual (Page 205)

4-54 Heater, air conditioner, audio and phone systems
SAA3385
CONTROL BUTTONS
The control buttons for the Bluetooth
®
Hands-
Free Phone System are located on the steering
wheel.
PHONE SEND
Push the button to initiate a VR session or
answer an incoming call.
You can also use the button to interrupt
system feedback and give a command at once.
PHONE END
While the voice recognition system is active,
push the
button to go back one step. Push
and hold the button for 5 seconds to quit
the voice recognition system at any time.
GETTING STARTED
The following procedures will help you get
started using the Bluetooth
®
Hands-Free Phone
System with NISSAN Voice Recognition. For
additional command options, refer to “List of
voice commands” (P.4-56).
Choosing a language
You can interact with the Bluetooth
®
Hands-
Free Phone System using English, Spanish or
French.
To change the language, perform the following.
1. Push and hold the button for more than
5 seconds.
2. The system announces: “Push the PHONE
SEND ( ) button for the hands-free
phone system to enter the speaker adapta-
tion mode or push the PHONE END (
)
button to select a different language.”
3. Push the button.
For information on speaker adaptation, see
“Speaker Adaptation (SA) mode” (P.4-59).
4. The system announces the current language
and gives you the option to change the
language to Spanish (in Spanish) or French
(in French). To select the current language,
press the
button. To select a different
language, tilt the tuning switch ( or )
up or down.
NOTE:
You must press the
button within 5
seconds to change the language.
5. If you decide not to change the language, do
not push either button. After 5 seconds, the
VR session will end, and the language will
not be changed.
Connecting procedure
NOTE:
The connecting procedure must be per-
formed when the vehicle is stationary. If
the vehicle starts moving during the pro-
cedure, the procedure will be cancelled.
1. Push the button on the steering wheel.
The system announces the available com-
mands.
2. Say: “Connect Phone”
*
A . The system
acknowledges the command and an-
nounces the next set of available commands.