NISSAN 2014 JUKE - Owner's Manual - Manual (Page 166)

Heater operation
Heating:
This mode is used to direct heated air to the foot
outlets.
1. Move the air intake lever to the position.
2. Turn the air flow control dial to the
position.
3. Turn the fan speed control dial to the
desired position.
4. Turn the temperature control dial to the
desired position between the middle and the
hot (right) position.
Ventilation:
This mode directs outside air to the side and
center ventilators.
1. Move the air intake lever to the position.
2. Turn the air flow control dial to the
position.
3. Turn the fan speed control dial to the
desired position.
Defrosting or defogging:
This mode directs the air to the defroster outlets
to defrost/defog the windows.
1. Move the air intake lever to the position.
2. Turn the air flow control dial to the
position.
3. Turn the fan speed control dial to the
desired position.
4. Turn the temperature control dial to the
desired position between the middle and the
hot (right) position.
. To remove frost from the outside surface of
the windshield quickly, turn the temperature
control dial to the maximum hot position and
the fan speed control
dial to the
maximum position.
. When the position is selected, the air
conditioner will automatically turn on. This
will dehumidify the air and help to defog the
windows.
Bi-level heating:
This mode directs cool air from the side and
center vents and warm air from the foot outlets.
When the temperature control dial is turned to
the maximum hot or cool position, the air
between the ventilators and the foot outlets is
the same temperature.
1. Move the air intake lever to the position.
2. Turn the air flow control dial to the
position.
3. Turn the fan speed control dial to the
desired position.
4. Turn the temperature control dial to the
desired position.
Heating and defogging:
This mode heats the interior and defogs the
windows.
1. Move the air intake lever to the position.
2. Turn the air flow control dial to the
position.
3. Turn the fan speed control dial to the
desired position.
4. Turn the temperature control dial to the
desired position.
When the position is selected, the air
conditioner will automatically turn on. This will
dehumidify the air and help to defog the
windows.
Air conditioner operation
The air conditioner system should be operated
for approximately 10 minutes at least once a
month. This helps prevent damage to the air
conditioner system due to the lack of lubrication.
Cooling:
This mode is used to cool and dehumidify the air.
1. Move the air intake lever to the position.
2. Turn the air flow control dial to the
position.
3. Turn the fan speed control dial to the
desired position.
Heater, air conditioner, audio and phone systems 4-15