Changing engine oil filter -10 – NISSAN 2015 Versa Note - Owner's Manual User Manual

Page 315

Advertising
background image

3. Remove the oil filler cap

B

by turning it

counterclockwise.

4. Place a large drain pan under the drain plug

A

.

5. Remove the drain plug

A

with a wrench by

turning it counterclockwise and completely
drain the oil.

If the oil filter is to be changed, remove and
replace it at this time. See “Changing engine
oil filter” in this section.

WARNING

Prolonged and repeated contact with

used engine oil may cause skin cancer.

Try to avoid direct skin contact with

used oil. If skin contact is made, wash
thoroughly with soap or hand cleaner as
soon as possible.

Keep used engine oil out of reach of

children.

CAUTION

Be careful not to burn yourself. The en-

gine oil may be hot.

Waste oil must be disposed of properly.
Check your local regulations.

6. Clean and reinstall the drain plug

A

and a

new washer. Securely tighten the drain plug

A

with a wrench. Do not use excessive

force.

Drain plug tightening torque:

22 - 29 ft-lb (29 - 39 N·m)

7. Refill engine with recommended oil through

the oil filler opening, then install the oil filler
cap

B

securely.

See “ Recommended fluids/lubricants and
capacities” in the “Technical and consumer
information” section of this manual for drain
and refill capacity.

The drain and refill capacity depends on the
oil temperature and drain time. Use these
specifications for reference only. Always use
the dipstick to determine when the proper
amount of oil is in the engine.

8. Start the engine. Check for leakage around

the drain plug

A

and oil filter. Correct as

required.

9. Turn the engine off and wait more than

10 minutes. Check the oil level with the
dipstick. Add engine oil if necessary.

CHANGING ENGINE OIL FILTER

1. Park the vehicle on a level surface and apply

the parking brake.

2. Turn the engine off.

3. Place a large drain pan under the oil filter

B

.

LDI2365

8-10

Maintenance and do-it-yourself

Advertising