NISSAN 2015 Versa Note - Owner's Manual - Manual (Page 51)

2nd row bench seat
Outboard seating positions
1. Remove the head restraint/headrest and
store it in a secure place. Be sure to reinstall
the head restraint/headrest when the child
restraint is removed. For additional infor-
mation, refer to “Head restraints/
headrests” in this section for head
restraint/headrest
adjustment,
removal and installation information.
2. Position the top tether strap
᭺
1 over the
seatback.
3. Secure the tether strap to the tether anchor
point
᭺
2 on the bottom of the seatback be-
hind the child restraint.
4. Tighten the tether strap according to the
manufacturer’s instructions to remove any
slack.
Center seating position
1. Remove the head restraint/headrest and
store it in a secure place. Be sure to reinstall
the head restraint/headrest when the child
restraint is removed. For additional infor-
mation, refer to “Head restraints/
headrests” in this section for head
restraint/headrest
adjustment,
removal and installation information.
2. Position the top tether strap
᭺
1 over the
seatback.
3. Secure the tether strap to the tether anchor
point
᭺
2 on the bottom of the seatback be-
hind the child restraint.
4. Tighten the tether strap according to the
manufacturer’s instructions to remove any
slack. Make sure the head restraint/headrest
does not contact the top tether strap.
If you have any questions when installing a
top tether strap, consult your NISSAN
dealer for details.
WARNING
Child restraint anchorages are designed
to withstand only those loads imposed by
correctly fitted child restraints. Under no
circumstances are they to be used to at-
tach adult seat belts, or other items or
equipment to the vehicle. Doing so could
damage the child restraint anchorages.
The child restraint will not be properly
installed using the damaged anchorage,
and a child could be seriously injured or
killed in a collision.
FORWARD-FACING CHILD
RESTRAINT INSTALLATION USING
THE SEAT BELTS
WARNING
The three-point seat belt with Automatic
Locking Retractor (ALR) must be used
when installing a child restraint. Failure to
use the ALR mode will result in the child
restraint not being properly secured. The
restraint could tip over or be loose and
cause injury to a child in a sudden stop or
collision. Also, it can change the operation
of the front passenger air bag. See “Front
passenger air bag and status light” in this
section.
When installing a child restraint system in
the rear center position, both the center
seat belt connector tongue and buckle
tongue must be secured. See “Attaching
the center seat belt” in this section.
1-34 Safety—Seats, seat belts and supplemental restraint system