Jeppesen FliteDeck 3 - Manual (Page 210)

Satellite Weather
213
or
To complete the JWC update:
1. Click OK and finish the FliteDeck update.
2. Open the Windows Services console by using one of the following methods:
• Click Start > Run, enter services.msc, and then click OK.
• Click Start > Settings > Control Panel > Administrative Tools,
and then double-click Services.
• Click Start > Settings > Control Panel > Performance and
Maintenance > Administrative Tools, and then double-click
Services.
3. Find Jeppesen Weather Controller Services in the list and right-click on it.
4. Select Properties. In the General tab, change Startup type to Manual.
5. Close everything and reboot the computer.
6. When the computer reopens, navigate to C:\Jeppesen\FliteDeck\Utils.
7. Double-click on JeppesenWeatherServiceSetup.exe and follow the
installer instructions.
Weather Products
To select the weather products seen in FliteDeck:
1. Click the Chart Setup tab.
2. Click Weather Options. The enroute chart options change to display weather
options.
3. Select or clear the weather products you wish to view.
Unlike the chart data products, the weather products do not have a decluttering
mechanism to help manage chart elements. Once the products are turned on, they
display in all incremental zoom levels below the default opening setting. Most
weather products begin to display when the view is set at approximately 600 nautical
miles per square inch. METARs display when the view is at 500 nautical miles per
square inch. Display the
graphic scale to determine the view scale.
TIP
FliteDeck uses your system clock to determine if a weather product can
display by comparing the system time to the entry and expiration dates