Jeppesen FliteDeck 3 - Manual (Page 269)

JeppView FliteDeck User's Guide
272
1. Click Start > Control Panel > Tablet and Pen Settings.
2. In the Tablet and Pen Settings dialog box, select the Settings tab and click
Calibrate.
3. Click OK when finished.
When I try to edit my route using the rubberband method or resize my
enroute chart using a zoom draw, the pen thinks I want to do a right-click.
How do I fix this?
Change the amount of time that you must press and hold before a right-click menu
takes effect:
1. Click Start > Control Panel > Tablet and Pen Settings.
2. In the Tablet and Pen Settings dialog box, select the Pen Options tab.
3. In the Pen Action section, select Press and hold, and click Settings.
4. In the Right-click mode activation section, adjust the speed slider toward
Long.
You will need to hold the pen down for a longer period of time before a right-click
equivalent is activated.
Every time I get the pen close to the enroute or terminal chart, it thinks I
want to perform a zoom draw. How do I fix this?
You need to adjust the point spatial tolerance on your tablet PC:
1. Click Start > Control Panel > Tablet and Pen Settings.
2. In the Tablet and Pen Settings dialog box, select the Pen Options tab.
3. In the Pen Action section, select Point/Hover, and click Settings.
4. Adjust the spatial tolerance slider toward Large.
Your hand will be able to move around more when you point.
When I perform a zoom draw on an enroute chart or on the terminal chart,
the blue zoom box appears but nothing happens when I release the mouse
button or remove the pen. It acts as if it is waiting for another action.
The ClickLock setting may be selected. With ClickLock on, you need to click or tap
again on the screen in order for the zoom to take place. To turn ClickLock off so that
the zoom takes place as soon as you release the mouse button or the pen:
1. Click Start > Control Panel > Mouse.
2. In the Mouse Properties dialog box, clear the ClickLock check box.