Intermittent wiper system, Windshield wiper operation – Dodge 2013 Journey - Owner Manual User Manual

Page 230

Advertising
background image

Intermittent Wiper System

Use the intermittent wiper system when weather condi-
tions make a single wiping cycle, with a variable pause
between cycles, desirable. Rotate the end of the wind-
shield wiper/washer control lever to one of the first five
detents to select the desired delay interval.

There are five delay settings, which allow you to regulate
the wipe interval from a minimum of one cycle every
two seconds to a maximum of approximately 36 seconds
between cycles at vehicle speeds below 10 mph (16 km/h).
At speeds greater than 10 mph (16 km/h), the delay varies
from a minimum of one cycle every second to a maximum
of approximately 18 seconds between cycles.

NOTE:

The wiper delay times depend on vehicle speed.

If the vehicle is moving less than 10 mph (16 km/h),
delay times will be doubled.

Windshield Wiper Operation

Rotate the end of the lever upward, to the first detent past
the intermittent settings for low-speed wiper operation.
Rotate the end of the lever upward to the second detent past
the intermittent settings for high-speed wiper operation.

Front Wiper Control

228

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Advertising