Cabletron Systems Cabletron CyberSWITCH CSX400 - Manual (Page 71)

Installation
CSX400 and CSX400-DC User’s Guide 57
To install an EPIM, perform the following steps:
1. Attach the disposable grounding strap to your wrist (refer to the instructions outlined on the
disposable grounding strap package).
2. Remove the coverplate or the existing EPIM (whichever applies).
3. Slide your new EPIM into place, making sure the connectors on the rear of the module and
inside the CSX400 attach properly as shown in
Figure 11 .
4. Install the mounting screw.
Figure 11 Installing an EPIM
!
CAUTION
When removing an existing EPIM, make sure to pull the module straight out to avoid
damaging the connector.
ETHERNET 1 ETHERNET 2
Mounting
Screw
EPIM