Cabletron Systems Cabletron CyberSWITCH CSX400 - Manual (Page 149)

General Configuration Using Local Management
CSX400 and CSX400-DC User’s Guide 135
Flash Download — The Flash Download screen allows you to download a firmware image from
a TFTP server to the CSX400.
Bridge Setup — The Bridge Setup screen allows you to select a Spanning Tree protocol and
enable/disable switch ports.
Router Setup — The Router Setup screen accesses two other screens that provide general IP or
IPX routing configuration and allow you to enable or disable the Routing Information Protocol
(RIP) and the Service Advertisement Protocol (SAP) features.
WAN Setup – The WAN Setup menu item accesses two other screens that provide WAN physical
configuration and WAN Interface configuration access to enable a WAN link to be set up.
System Level Screen
The System Level screen displays the physical address (MAC address) of the CSX400 and allows
you to set the following parameters:
• System Date
• System Time
• Host IP Address
• Subnet Mask
• Default Gateway
• Default Interface
NOTE
If you have a WPIM-HDSL installed in your CSX400, refer to the WAN Setup section of
this chapter for configuration information. For all other WPIMs, refer to your specific
WPIM(s) Local Management Guide for information on configuring the CSX400 for a
Wide Area Network Interface
.