Cabletron Systems Cabletron CyberSWITCH CSX400 - Manual (Page 21)

About the CSX400
CSX400 and CSX400-DC User’s Guide 7
• The WPIM-T1/DDS provides both a T1 and DDS interface that allows you to easily switch
between the two interfaces by changing the physical cabling and reconfiguring QuickSET for
the desired interface. The WPIM-T1/DDS has the capabilities of both the WPIM-T1 and
WPIM-DDS.
Ethernet LAN Connection
The CSX400 provides 10 Mbps Ethernet/IEEE 802.3 support through two Cabletron Systems
Ethernet Port Interface Modules (EPIMs), which are available in a variety of media types.
Appendix A , EPIM Specifications , details the available EPIMs that can be used to configure the
CSX400 for an Ethernet connection.
FLASH EEPROMs — The CSX400 uses a FLASH Electrically Erasable Programmable
Read-Only Memory (EEPROM) that allows new and updated firmware to be downloaded in
conjunction with Cabletron Systems QuickSET or any device using BootP or TFTP protocols.
LANVIEW LEDs — Cabletron Systems LANVIEW Status Monitoring and Diagnostics System is
a troubleshooting tool that helps in the diagnosing of power failures, collisions, cable faults, and
link problems. The LANVIEW LEDs are located on the CSX400 front panel.
RESET Button — The front panel RESET button reboots the CSX400 and initializes the
processor. The RESET button also is used with the mode switches to clear NVRAM.
Remote Management Capabilities
The CSX400 can be remotely managed with any SNMP network management system including
the following:
• Cabletron Systems SPECTRUM for Open Systems
• Cabletron Systems Remote SPECTRUM Portable Management Applications (SPMAs)
• Cabletron Systems QuickSET
• Cabletron Systems SPECTRUM Element Manager (SPEL)
• Third Party SNMP compliant Network Management Packages