Cabletron Systems Cabletron CyberSWITCH CSX400 - Manual (Page 74)

Installation
60 CSX400 and CSX400-DC User’s Guide
Installing WAN Port Interface Modules (WPIMs)
To install a WPIM into the CSX400, refer to Figure 13 and complete the following steps:
1. Attach the disposable grounding strap to your wrist (refer to the instructions outlined on the
disposable grounding strap package).
2. Remove the CSX400 cover (refer to Removing the CSX400-DC Cover for instructions).
3. Remove the blank faceplate from the appropriate WAN slot.
4. Orient the WPIM as shown in Figure 13 .
5. Carefully insert the WPIM connector into the WPIM connector pins on the CSX400.
6. Press down firmly on the WPIM until the pins slide all the way into the connector. Ensure that
the WPIM seats flush on the standoffs.
7. Secure the WPIM to the three standoffs using the provided screws.
8. Replace the CSX400 cover.
!
CAUTION
Before performing installation procedures, ensure that the requirements outlined in the
section,
Guidelines for Installations , are met.
!
CAUTION
When removing an existing WPIM, make sure to pull the module straight out to avoid
damaging the connector.