Cabletron Systems Cabletron CyberSWITCH CSX400 - Manual (Page 78)

Installation
64 CSX400 and CSX400-DC User’s Guide
2. Peel the paper backing off the round rubber feet, and adhere them to the bottom of the CSX400.
Place one rubber foot near each of the four corners of the CSX400, and evenly space the
remaining two near the center.
Figure 15 Tabletop or Shelf Installation
Continue the installation by connecting power as described in Connecting the CSX400-DC to the
Power Source .
CSX400 and CSX400-DC Rackmount Installation
There are two methods of attaching the rackmount brackets, included with the CSX400 and
CSX400-DC, that are discussed in this section.
Attaching the Rackmount Brackets to the
CSX400 discusses a typical installation of the CSX400, and Bonding the Rackmount Brackets
to the CSX400-DC discusses the GR-1089-CORE Section 9 bonding requirements for the
CSX400-DC when installing rackmount brackets. Refer to the procedure that applies to your
installation.
Rackmounting the CSX400 requires the following steps:
• Attaching the rackmount brackets
• Installing the CSX400 in a 19-inch rack
• Connecting the CSX400 to a power source
Tools Required
• Phillips screwdriver
WARNING
Before installing the CSX400 or CSX400-DC into a rack, ensure that the rack supports
the device(s) without compromising the stability of the rack. Otherwise, personal injury
and/or equipment damage may result.
18 IN.
16 IN.
21 IN.