Line interface management modules (lim), About lim cards, Removing a lim card – Cisco SFS 7008 User Manual

Page 45: About lim cards removing a lim card, Upgrade the image with the cli, Upgrade the image with the chassis manager, Upgrade the image with the element manager, About a failed lim module, Locating a failed lim module

Advertising
background image

45

Upgrade the Image with the CLI

To upgrade the image of the Controller card with the Command Line Interface, refer to

“Upgrading a

Controller Card with the CLI” on page 57

and the following document:

CLI Reference Guide

Upgrade the Image with the Chassis Manager

To upgrade the system image with the Chassis Manager web GUI, refer to the following document:

Chassis Manager User Guide

Upgrade the Image with the Element Manager

To upgrade the system image with the optionally licensed Element Manager GUI, refer to the following
documents:

Element Manager User Guide

Line Interface Management Modules (LIM)

About LIM Cards

Refer to

“Line Interface Modules (LIM)” on page 19

for specific information about the LIM modules.

About a Failed LIM Module

If you believe a line interface module has failed, contact technical support.
Refer to

“LIM Status LEDs” on page 75

and

“Monitor the Cards” on page 79

for monitoring

information.

Locating a Failed LIM Module

The Line Interface Management modules are located on the back of the chassis. Refer to

Figure 1-2

for

a diagram of the chassis.

Removing a LIM Card

1. Ground yourself appropriately.
2. Verify that you have a means of covering the slot before removing the module. Do not remove the

module unless you have a replacement or a blanking panel for the slot, as overheating may occur.

Advertising