Dell PowerEdge Rack Enclosure 4020S - Manual (Page 28)

26
Installation Guide
6 Rotate the window.
a Place the door down on the floor.
b Using a 10 mm wrench, remove all the nuts that secure the window to
the front door. See Figure 13.
NOTE:
It is recommended that you place the door on a smooth and clean
surface in order to minimize risk of scratching the window and the Dell badge.
c Remove the top and bottom end caps and slide the window out
through the top or bottom end of the door. See Figure 13.
NOTE:
While reinstalling the window, ensure that the Dell badge is on the
same side of the door as the handle.
d Rotate the window and slide it back into the door such that the badge
is now located at opposite end of the door.
e Install the top and bottom end caps and install all the nuts that secure
the window to the front door. See Figure 13.
Figure 13. Rotating the Front Door Window
1 nuts 2 end caps (2)
3 window
1
2
3