Dell PowerEdge Rack Enclosure 4020S User Manual
Page 30
Advertising
28
Installation Guide
8 Rotate the handle.
a
Open the handle and ensure that the two screws are accessible.
b
Mark the linkage position relative to the inside door trim using a piece
of tape or a marking device. See Figure 15.
c
Using a T20 Torx screwdriver, remove the two screws that secure the
handle. See Figure 15.
d
Rotate the handle. See Figure 15.
Figure 15.
Rotating the Front Door Handle
e
With the handle in the open position and linkage marks aligned, align
the handle holes and install the screws. See Figure 15.
NOTE:
If a piece of tape was used to mark the linkages, remove the tape.
1
handle
2
screws (2)
2
1
Advertising