Dell C/Dock II Expansion Station User Manual
Page 24
22
S y s t e m I n f o r m a t i o n G u i d e
www
.dell.com | support.dell.com
P C I E x p a n s i o n - S l o t D o o r a n d E x p a n s i o n - C a r d C o n n e c t o r
7
Remove the top cover by pressing the two side buttons and rotating
the cover toward the back of the docking device. Once the cover is
rotated back, disengage the hinge tabs from the back of the docking
device, and fully remove the top cover.
See the figure “Removing the Top Cover.”
8
Remove the screw holding the empty mounting bracket and set aside
for future use.
Remove the empty mounting bracket. If a PCI card is installed,
remove it by grasping the card by its outside corners, and easing it out
of its connector.
9
Install a PCI expansion card.
a
Insert the card-edge connector of the card firmly into the
expansion-card connector.
b
Gently rock the card side to side into the connector until it is fully
seated.
10
Reseat the screw in the PCI card bracket to secure the PCI card.
11
Replace the top cover by first engaging the hinge tabs and gently
lowering the front of the top cover into place. The top cover will be
properly aligned when you hear the side buttons click into place.
PCI expansion-slot door