Canon MF5550 - Manual (Page 11)

ix
Legal Notices
Users in the U.S.A.
Pre-installation Requirements for Canon Facsimile Equipment
A. Location
Supply a suitable table, cabinet, or desk. For the machine's dimensions and weight,
see Chapter 11, "Appendix," in the
Basic Guide .
B. Order Information
1. Only a single line, touch-tone or rotary telephone set is to be used.
2. Order an RJ11-C modular jack (USOC code), which should be installed by the
telephone company. If the RJ11-C jack is not present, installation cannot occur.
3. Order a normal business line from your telephone company's business
representative. The line should be a regular voice grade line or the equivalent.
Use one line per machine.
DDD (DIRECT DISTANCE DIAL) LINE
-or-
IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU COMMUNICATE
OVERSEAS
NOTE
Canon recommends an individual line following industry standards, e.g., the 2,500
(Touch Tone) or 500 (Rotary/Pulse Dial) telephones. A dedicated extension off a PBX
unit without "Call Waiting" can be used with the imageCLASS MF5550. Key telephone
systems are not recommended because they send non-standard signals to individual
telephones for ringing and special codes, which may cause a fax error.
C. Power Requirements
This equipment should be connected to a standard 120-volt AC, three-wire
grounded outlet only. Do not connect this machine to an outlet or power line shared
with other appliances that cause "electrical noise." Air conditioners, electric
typewriters, copiers, and machines of this sort generate electrical noise which often
interferes with communications equipment and the sending and receiving of
documents.