Canon MF5550 - Manual (Page 73)

LCD Messages 7-3
T
roub
leshooting
7
NOT REGISTERED
Cause The one-touch speed dialing key or coded speed dialing code you entered is
not registered.
Remedy Register the one-touch speed dialing key or coded speed dialing code. For
more information, see the following:
• "Registering One-Touch Speed Dialing," on p. 3-2
• "Registering Coded Speed Dialing," on p. 3-4
RECEIVED IN MEMORY
Cause The machine received the fax in the memory because paper or toner ran out, a
paper jam occurred, or incorrect paper size was loaded.
Remedy Load correct paper size in the cassette, replace the cartridge, or clear the paper
jam. For more information, see the following:
• Chapter 2, "Paper Handling," in the Basic Guide
• Chapter 8, "Maintenance," in the Basic Guide
• Chapter 9, "Troubleshooting," in the Basic Guide
REMOVE MP PAPER
Cause Paper is loaded in the multi-purpose feeder.
Remedy Remove the paper from the multi-purpose feeder.
If the machine receives the fax when paper is loaded in the multi-purpose
feeder, the received document will be stored in the memory.
SELECT A4/LTR/LGL
Cause When the machine is receiving a fax, the paper size setting is set to a size other
than LTR, LGL, or A4.
Remedy Set the paper size setting to LTR, LGL, or A4 and load paper of the same size.
The machine automatically prints the fax which was stored in the memory.
TX LIMIT REACHED
Cause The fax jobs stored in the memory reached the maximum.
Remedy Wait for the machine to send any faxes stored in the memory, then try sending
again.