Dell POWERVAULT MD3620F User Manual

Page 13

Advertising
background image

Getting Started With Your System

11

3 Insert the cable into an SFP module that is installed in the storage array.

The cable connector is keyed for correct installation. Holding the
connector, push in the cable until it clicks into place.

4 Remove the two protective caps from the other end of the cable and store

them future use.

5 Connect this end of the cable to one of the following devices:

An SFP module that is installed in an FC switch port

A FC HBA port

To remove an FC cable:

1 Press and hold the lever to release the latches before removing the cable

from the SFP module. Ensure that the levers are in the released position
when removing the cable. Do not grasp the SFP module plastic tab when
removing the cable.

2 On the end of the cable that connects into the SFP module or HBA,

press down and hold the lever to release the latches.

3 While pressing down the cable lever, pull the connector to remove the

cable from the SFP module.

4 Replace the protective caps on the cable ends.
5 Replace the protective cap on the SFP module.

Advertising
This manual is related to the following products: