Dell Inspiron 660s (Early 2012) - Manual (Page 51)

Front I/O Panel
47
Front I/O Panel
WARNING:
Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 9. For additional safety best practices information, see the Regulatory
Compliance Homepage at dell.com/regulatory_compliance.
Removing the Front I/O Panel
Prerequisites
1 Remove the computer cover. See "Removing the Computer Cover" on
page 17.
2 Remove the fan shroud. See "Removing the Fan Shroud" on page 19.
3 Remove the front bezel. See "Removing the Front Bezel" on page 33.
4 Remove the drive cage. See "Removing the Drive Cage" on page 37
5 Remove the PCI-Express x16 card, if applicable. See "Removing the PCI-
Express Cards" on page 25.
Procedure
1 Disconnect the front I/O panel cables from the system-board connectors
(USBF1, USBF2, and AUDF1 ). See "System Board Components" on
page 15.
NOTE:
Note the routing of all cables as you remove them so that you can re-
route them correctly after you replace the front I/O panel.
book.book Page 47 Thursday, April 5, 2012 5:38 PM