Dell Inspiron 660s (Early 2012) - Manual (Page 65)

Processor Fan and Heat-Sink Assembly
61
Replacing the Processor Fan and
Heat-Sink Assembly
Procedure
CAUTION:
Incorrect alignment of the processor fan and heat-sink assembly can
damage the system board and processor.
NOTE:
The original thermal grease can be reused if the original processor and
processor fan and heat-sink assembly are reinstalled together. If either the
processor or the processor fan and heat-sink assembly is replaced, use the thermal
grease provided in the kit to ensure that thermal conductivity is achieved.
1 Apply new thermal grease to the top of the processor, if applicable.
2 Place the processor fan and heat-sink assembly over the processor.
3 Align the captive screws on the processor fan and heat-sink assembly with
the screw holes on the system board.
4 Tighten the captive screws that secure the processor fan and heat-sink
assembly to the system board.
5 Connect the processor fan cable to the system-board connector
(FANCPU1). See "System Board Components" on page 15.
Postrequisites
1 Replace the fan shroud. See "Replacing the Fan Shroud" on page 20
2 Replace the computer cover. See "Replacing the Computer Cover" on
page 18.
3 Follow the instructions in "After Working Inside Your Computer" on
page 11.
book.book Page 61 Thursday, April 5, 2012 5:38 PM