Dell Inspiron 660s (Early 2012) - Manual (Page 56)

52
Power Button Module
Procedure
1 Disconnect the power-button module cable from the system-board
connector (LEDH1). See "System Board Components" on page 15.
2 Remove the power-button module cable from the routing guides on the
chassis.
3 Press the power-button module tabs to release the power-button module
from the front panel.
4 Slide the power-button module along with its cable through the slot on the
front panel.
5 Set the power-button module aside in a secure location.
1 routing guide 2 power-button module
3 power-button module cable 4 tabs (2)
3
1
2
4
book.book Page 52 Thursday, April 5, 2012 5:38 PM