Dell DR4000 - Manual (Page 5)

Dell DR Series System Interoperability Guide, Release 3.1.2 | 5
Introduction
This document provides information about supported hardware and software versions for the Dell DR
Series system, release 3.1.2. This document also includes information about the supported capacities
and hypervisor versions for the Dell DR2000v.
Supported Hardware for Physical DR Series Systems
This section lists the hardware supported by the physical system on which DR Series software is
installed. Where applicable, firmware and driver versions are also listed.
RAID Controllers
System
RAID
Controller
Max # of
Controllers
DR4000 1 PERC H700 1
PERC H800 1
DR4100 1
DR6000
PERC H710P 1
PERC H810 1
1
DR4000/DR4100 with 2.7 TB base unit does not support expansion.
Hard Drives (Base Unit)
System Drive Slot Drive Type RAID Level
DR4000
DR4100
DR6000
0 Hot-swappable 3.5-inch SAS drive
(global hot spare)
N/A
1-11 Eleven (11) hot-swappable 3.5-inch SAS
or Nearline SAS Hard Disk Drives (HDD)
6
12-13 2 Two (2) 2.5-inch SAS Hard Disk Drives
(HDD)
1
2
Slots 12 and 13 are located in different locations within each appliance product. In the DR4000 system these
drives are internal, while in the DR4100 and DR6000 systems these drives are hot pluggable in the rear panel.
For information on locating these drives, see the appropriate product’s Dell DR Series Systems Owner’s Manual.
Capacities (Base Unit)
System Drive Capacities Supported
DR4000 2.7 TB, 5.4 TB, 9 TB, 18 TB, 27 TB
DR4100 2.7 TB, 5.4 TB, 9 TB, 18 TB, 27 TB
DR6000 9 TB, 18 TB, 27 TB, 36 TB