Dell Acceleration Appliances for Databases - Manual (Page 12)

First Boot Setup
_______________________________________________________________________
The ION Accelerator software comes pre-installed on the appliance.
The following tasks are handled in the First Boot of the ION Accelerator:
• License Agreement
• Network configuration, including management node and HA (if enabled)
• Date and time setup
• Cluster setup (if the HA feature is licensed)
• Password configuration
The screen examples shown in this section assume an HA configuration. If you are using ION
Accelerator in standalone (non-HA) mode, skip over the steps that apply to HA configuration.
If you need to adjust First Boot settings after the First Boot process has completed, use the
Network settings dialog (see
Network in Configuring ION Accelerator Settings) or the
setup:lan
command in the CLI (see setup:lan in the Command-Line Reference section of the
ION Accelerator CLI Reference).
ION Accelerator Configuration
After installation, the appliance OS scans for existing network cards, and detected controllers are
displayed. The sample screen below shows an example of detected controllers:
5