Dell PowerVault 57F - Manual (Page 17)

support.dell.com Using the Dell PowerVault Switch Manager 2-7
)
 *% 
The Zone Administration consists of the following functions:


Zone Alias Settings


Zone Settings


Zone Config Settings
NOTE: You should make Zone Administration changes incrementally. Changes to
the zoning information are transferred to the switches only when you click Apply; if
you have made a large number of changes, the fabric can become unusable while the
information is being updated on all the switches in the fabric. Dell recommends that
you click Apply to update the changes frequently when modifying the zoning
information.
Refresh button Click to refresh on demand
Domain # field Displays the domain ID of a switch to which each device
is connected
Port # field Displays the port number of the switch
Port ID field Displays the port ID of a device (Fibre Channel 24-bit ID
in hexadecimal)
Port Type field Displays the port type of a device (N for fabric direct
attached port or NL for fabric direct attached loop port)
Port WWN field Displays the WWN for a device port
Node WWN field Displays the WWN for a device node
Symbolic Name field Displays the symbolic name of a device reported by the
SCSI INQUIRY command
FC4 Types field (not
shown in Figure 2-3) Displays the Fibre Channel FC4 layer types supported
by device, such as IP and FCP
COS field (not shown
in Figure 2-3) Displays the Fibre Channel classes of service supported
by the device
Member of Zones field
(not shown in
Figure 2-3) Lists all the zones of which the device is a member
Done button Click to close the window

 ! 
"