Dell M209X Projector - Manual (Page 13)

Using Your Projector 13
3
Using Your Projector
Turning Your Projector On
NOTE: Turn on the projector before you turn on the source. The Power button
light blinks blue until pressed.
1 Remove the lens cap.
2 Connect the power cord and appropriate signal cables. For information about
connecting the projector, see "Connecting Your Projector" on page 7.
3 Press the Power button (see "Using the Control Panel" on page 17 to locate the
Power button ).
4 Turn on your source (computer, DVD player, etc.). The projector automatically
detects your source.
5 The Dell logo will be displayed if no signal detected.
If the "Searching for signal..." message appears on the screen, ensure that the
appropriate cables are securely connected.
If you have multiple sources connected to the projector, press the Source button
on the remote control or control panel to select the desired source.
Turning Your Projector Off
NOTICE: Unplug the projector after properly shutting down as explained in the
following procedure.
To turn off the projector:
1 Press the Power button .
2 Press the Power button again to turn off the projector.
The projectors cooling fans are on for 90 seconds before the projector switches off
completely.
3 To power off the projector quickly, press the Power button while the projectors
cooling fans are still running.
NOTE: Before you turn on the projector again, wait for 60 seconds to allow the
internal temperature to stabilize.