Dell M209X Projector - Manual (Page 29)

Using Your Projector 29
3 To cancel the password function, select OFF and enter the password to
disable the function.
C
HANGE PASSWORD
—Allows you to change the password. Key in the original
password and then enter the new password. Enter the new password again to
confirm.
T
EST
P
ATTERN
—Select 1 or 2 to activate the built-in Test Pattern to test the focus
and resolution. Select Off to disable the function.
1 To run the diagnostics test pattern 1, press and hold the Menu button and
button on the projectors control panel simultaneously for two seconds.
2 To run the diagnostics test pattern 2, press and hold the Menu button and
button on the projectors control panel simultaneously for two seconds.
NOTE: To enable test pattern 2, it is required to connect an input signal to
projector.
F
ACTORY
R
ESET
—Select On to reset the projector to its factory default settings.